SD modulis 4050v1.0 plastikine tarpine ekrano kabelis su spausdinta dalys LEO 3d spausdintuvas atnaujinti
Tinka LEO 3d spausdintuvas atnaujinti rinkinys Pakuotė : 1.6 pin (6mm) *1 2.SD modulis 4050v1.0 *1 3.Ekrano kabelis *1 4.Plastikinės tarpinės*4 5. Spausdinti dalys *1
Uraiskums
2020-10-09 5/5 |
ok, no complaints. |
Sveta Akobyan
2020-09-19 5/5 |
This set is absolutely needed to run the stock display on a Hiprecy Leo with an S6 controllerboard. With the original cardreader which ran with the F6 controllerboard I was unable to read SD cards with the 32 bit S6 installed. I already tested the new version and it is working nicely now. Beware: my wire harness came with the EXP1 connector 180 degrees turned. I had to remove the wires and re-insert them correctly. Fortunately, this swap didn't cause disasters...boards usually don't like swapped powerlines. |